WiFi GPS NTP Sync Device for Nixie Clocks "Flashed TESTED Done" + Ready To Use

Description: WiFi NTP Sync Device for Nixie Clocks - Flashed Done !Main FunctionThe FakeGPS requests the UTC-Time from a NTP-Server over WiFi and Internet and generates a GPRMC-Message in the GPS-Format NMEA-0183 as required from the Clock. Because the GPS-Time normally is UTC-time without localisation or DST-information the clock with original receiver has to be set in DST-mode manually on every DST-change. What you need to connect the audio plugin wire to device? The serial signal comes from Pin TXD1 (GPIO2, D4) of the NodeMCU with 9600 baud. Connect the audioplug to 5V, GND and Signal as described in the assembly instructions of the clock and configure the timereceiver of the clock for GPS-Format and 9600 Baud. How to setup wifi info to device and use it ?On first usage or if the module can't connect to the local WiFi-network it starts as accesspoint named "NixieAP". Connect to this AP and configure the SSID and Key of your local network. Then the module will connect to your network, act as NTP-server and keep the access-data for the next start. More Introduction:The NTP Sync Device provides a convenient and low cost method to synchronise time and date on our compatible Nixie Clocks.On a factory power up, the device sets up in Access Point (AP) Mode. This is a wireless network that you can connect to with your computer or Smartphone. Once connected, you use your Smartphone to enter some simple configuration settings and then re-boot the module. The module then powers up in active mode, which will connect to your home WiFi network and retrieve the time and date from an NTP server of your choice. Time and date are sent to the clock as a 'fake' GPS Data Sentence. Package Included:1x Device Case1x WiFi GPS NTP Sync Device What other hardware you need ?audioplug with 3 wires as you see on the photo !

Price: 19.89 USD

Location: Las Vegas, Nevada

End Time: 2024-08-18T04:59:34.000Z

Shipping Cost: 2.78 USD