Grand Thane w/ Base - GHAMAK 32mm

Description: This listing is a printed version of a unit made by GHAMAK. With a authorized merchant license by the GHAMAK merchant tier on Patreon. The base options for this are the textured bases that come with these models, printed in resin. the square base & round base options are 25mm Square. Pictures of the bases are in the pictures above. If you wish to sub the textured bases for blank resin bases, make a note in the order when placed.These will be printed in high quality ABS-Like Resin, this is a important distinction, as normal resin has the tendency to be more brittle/fragile, ABS-Like resin instead of being brittle/fragile will be more bendy instead and more resistant to damage from dropping. These prints will also be made by a Elegoo Saturn 3 Ultra 12k. *I highly recommend using Gorilla Gel super glue, plastic glue will not work*To see the quality of miniatures to expect you can check out https://thepeckingorder.org/3d-print-requests where I have a bunch of other prints I have done for people. Which for personal print requests outside of this listing you may request there.Models will be printed, washed, and cured. You may have some lingering supports, they are very easy to remove via a hobby knife, some with your finger, once in a while there may also be some left over residue from the wash that gives a *wet* look, just swish around in warm soapy water or in alcohol and your good to go. Also if models seem too bendy to you or you think they arent cured enough, just put out in the sun for a couple minutes and they will stiffen/harden up but this will increase fragility. These dwarves come mostly whole, so not much assembly required.These are also labeled as on-demand. They may be printed as ordered if there is no backstock of them.

Price: 7.65 USD

Location: Centralia, Washington

End Time: 2024-10-02T22:36:57.000Z

Shipping Cost: N/A USD