GC Gold Label 9 Posterior Restorative GIC

Description: Features:Chemical adhesion to tooth structure allows minimal cavity preparation without the need for etching or bonding agentsA chemical setting without shrinkage allows single-step placement without layeringSimilar thermal expansion as tooth structure produces minimal stress on the marginal sealStrontium-based glass provides good radiopacity and snap-set characteristics unanimously preferred by cliniciansStrontium based fluoride-releasing formulation contributes to internal remineralization within tooth structure as well as increasing surface strength over timeHigh compressive and flexural strength, and 60% higher wear resistance than conventional glass ionomers make Gold Label 9 strong enough for use in posterior teeth Direction to Use:1. POWDER AND LIQUID DISPENSINGThe standard powder-to-liquid ratio is 3.4g/ 1.0g. (1 level scoop of powder to 1 drop of liquid).For accurate dispensing of powder, lightly tap the bottle against the hand. Do not shake or invert.To dispense the correct amount of liquid from the bottle turn the bottle upside down, keep the nozzle away from the mixing pad and gently press the bottle. Discard the first 1-2 drops after opening a new bottle as the dispensed amount may not be accurate.Close bottles tightly immediately after use.2. MIXINGDispense powder and liquid onto the pad. Using the plastic spatula, divide the powder into 2 equal parts. Mix the first portion with all the liquid for 10 seconds. Incorporate the remaining portion and mix the whole thoroughly for 15-20 seconds (Fig. 1).3. RESTORATIVE TECHNIQUEPrepare the tooth using standard techniques. Extensive mechanical retention is not necessary. For pulp capping, use calcium hydroxide.Apply GC CAVITY CONDITIONER (10 seconds) or GC DENTIN CONDITIONER (20 seconds) to the bonding surfaces using a cotton pellet or sponge (Fig. 2).Refer to the respective instructions for use.Rinse thoroughly with water. Dry by blotting with a cotton pellet or gently blowing with an air syringe. DO NOT DESICCATE. The best results are obtained when prepared surfaces appear moist (glistening) (Fig. 3).Mix the required amount of GC Gold Label IX GP-EXTRA. Working time is 2 minutes from the start of mixing at 23°C (73.4°F). Higher temperatures will shorten working time.Transfer cement to the preparation using a syringe or other suitable instrument. Avoid air bubbles.From the preliminary contour and cover with a matrix if required (Fig. 4). g) When set, immediately apply GC Fuji VARNISH (blow dry) or GC Fuji COAT LC (light cure for 10 sec.).4. FINISHINGFinal finishing under water spray using standard techniques can begin at 6 minutes after starting the mix.Apply a final coat of G-COAT PLUS and light cure for 20 sec. (Fig.5, 6). Alternatively, apply GC Fuji VARNISH (blow dry) or GC Fuji COAT LC (light cure for 10 sec.) Instruct the patient not to apply pressure for 1 hour. Packaging :Gc Gold Label 9 Extra - Big Pkg:1 x 15 g Powder1 x 8 g Liquid(6.4ml)Gc Gold Label 9 - Big Pkg:1 x 15 g Powder1 x 13.1 g (10.5mL)LiquidGc Gold Label 9 Extra - Mini Pack:1 x 5g Powder1 x 3g Liquid(2.4ml)Gc Gold Label 9 - Mini Pack:1 x 5 g Powder1 x 5 g Liquid(4ml)

Price: 50.8 USD

Location: PANIPAT, HARYANA

End Time: 2024-11-15T09:58:31.000Z

Shipping Cost: 0 USD